2.8 Answer the following:

(a)You are given a thread and a meter scale. How will you estimate the diameter of the thread?

 

(b) A screw gauge has a pitch of 1.0 mm and 200 divisions on the circular scale. Do you think it is possible to increase the accuracy of the screw gauge arbitrarily by increasing the number of divisions on the circular scale?

 

(c) The mean diameter of a thin brass rod is to be measured by vernier calipers. Why is a set of 100 measurements of the diameter expected to yield a more reliable estimate than a set of 5 measurements only?

According to question, we can write

Total moles of gas = n = n_Oxygen + n_Oxygen = $\frac{16}{2}+\frac{128}{32}=12moles$  

Volume of gas = 12 × 22.4 litre = 268.8 litre = 2.688 × 10⁵ cm³ $\approx 27\times 10^{4}c{m}^3$  

$K=\frac{\left(\frac{Q}{r}\right)\mathrm{\Delta }x}{\mathrm{\Delta }AT}$

$\begin{array}{ll}\Rightarrow & \frac{\left({\mathrm{M}\mathrm{L}}^2{\mathrm{T}}^{-2}\right)\left(\mathrm{L}\right)}{\left({\mathrm{L}}^2\right)\left(\theta \right)\left(\mathrm{T}\right)}\\ \Rightarrow \mathrm{}& {\mathrm{M}}^1{\mathrm{L}}^{1-}{\mathrm{T}}^{-3}{\theta }^{-1}\end{array}$

Viscosity = Pascal . Second

$P^X{A}^Y{T}^Z=\left[M^1{L}^{-1}{T}^{-1}\right]$        

=  ${\left[M^1{L}^{+1}{T}^{-1}\right]}^x\left[L^2\right]y{\left[T^1\right]}^z=M^{-1}{L}^{-1}{T}^{-1}$

= x = 1,     x + 2y = -1,      -x + z = 1

y = -1,              Z = 0

Viscosity = [P¹A^-1T⁰]

1 msD = 1mm

10 vsD = 9msD

1vsD = 0.9 MsD

L.C. = 1MSD – 1VSD = 1 – 0.9 = 0.1 mm

Zero error = 4LC = 0.4 mm

Reading = MSR + VSR + correction

= 4.1 cm + 6 * .01 cm + (-0.04 cm) = (4.1 + 0.06 – 0.04) cm

= 4.12 cm = 412 * 10^-2 cm

$\Delta Q=ms\Delta T\Rightarrow s=\frac{\Delta Q}{m\Delta T}\Rightarrow \left[s\right]=\frac{M{L}^2{T}^{-2}}{MQ}=L^2{T}^{-2}{Q}^{-1}$

$\Delta Q=mL\Rightarrow \left[L\right]=\frac{M{L}^2{T}^{-2}}{M}=L^2{T}^{-2}$